Blade Blade 180QX HD Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Quadcopters Blade Blade 180QX HD. Blade Blade 180QX HD 20 halaman.
Juga untuk Blade Blade 180QX HD: Buku Petunjuk (20 halaman)

Halaman Cetak

Troubleshooting Guide

Problem

Quadcopter control response

is inconsistent or requires

extra trim to neutralize move-

ment.

Quadcopter will not respond

to throttle.

Quadcopter does not function

and smells burnt after con-

necting the ﬂ ight battery.

Quadcopter has reduced ﬂ ight

time or is underpowered.

LED on receiver ﬂ ashes rapidly

and aircraft will not respond to

transmitter (during binding).

LED on the receiver ﬂ ashes

rapidly and the quadcopter will

not respond to the transmitter

(after binding).

Crashes immediately upon

lift-off

Possible Cause

Aircraft not initialized on a level sur-

face.

Battery not correctly placed in

battery slot.

Throttle too high and/or throttle trim

is too high.

Quadcopter moved during initialization.

Throttle channel is reversed.

Flight battery connected with the

wrong polarity.

Flight battery charge is low.

Inadequate power to ﬂ ight battery

charger.

Flight battery is damaged.

Flight conditions might be too cold.

Transmitter too near aircraft during

binding process.

Bind switch or button was not held

while transmitter was powered on.

Aircraft or transmitter is too close to

large metal object, wireless source or

another transmitter.

Less than a 5-second wait between

ﬁ rst powering on the transmitter and

connecting the ﬂ ight battery to the

quadcopter.

The quadcopter is bound to a different

model memory (ModelMatch™ trans-

mitters only).

Flight battery or transmitter battery

charge is too low.

Aircraft or transmitter is too close to

large metal object, wireless source or

another transmitter.

Propellers in wrong locations or

incorrect ﬂ ight mode selected.

Solution

Disconnect the ﬂ ight battery, center the

control trim and re-initialize the quadcopter.

Adjust battery position so quadcopter bal-

ances in the center of the frame.

Reset controls with the throttle stick

and throttle trim at the lowest setting.

Disconnect the flight battery and re-

initialize the quadcopter while keeping the

quadcopter from moving.

Disconnect ﬂ ight battery, reverse the

throttle channel on the transmitter,

recconnect ﬂ ight battery.

Replace the 5-in-1 board. Connect the

ﬂ ight battery noting proper polarity.

Completely recharge the ﬂ ight battery.

Use a different USB power source for the

charger.

Replace the ﬂ ight battery and follow the

ﬂ ight battery instructions.

Make sure the battery is warm (room tem-

perature) before use.

Power off the transmitter. Move the trans-

mitter a larger distance from the aircraft.

Disconnect and reconnect the ﬂ ight battery

to the aircraft. Follow the binding instruc-

tions.

Power off transmitter and repeat bind

process.

Move aircraft and transmitter to another

location and attempt binding again.

Leave the transmitter powered on. Discon-

nect and reconnect the ﬂ ight battery to the

quadcopter.

Select the correct model memory on the

transmitter. Disconnect and reconnect the

ﬂ ight battery to the quadcopter.

Replace or recharge batteries.

Move aircraft and transmitter to another

location and attempt connecting again.

Ensure propeller direction and motor

direction are correct.