Blade Blade 180QX HD Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Quadcopters Blade Blade 180QX HD. Blade Blade 180QX HD 20 halaman.
Juga untuk Blade Blade 180QX HD: Buku Petunjuk (20 halaman)

Halaman Cetak

Transmitter and Receiver Binding

To bind or re-bind your quadcopter to your chosen transmitter, please follow the directions below.

General Binding Procedure

1. Disconnect the ﬂ ight battery from the quadcopter.

2. Select a clean model memory on your transmitter (computer radios only).

3. Select Acro or Airplane model type on your transmitter.

4. Make sure all servo reversing is set to Normal on your transmitter.

5. Center all trims on your transmitter.

6. Power off the transmitter and move all switches to the 0 position. Move the throttle to the low/off position.

7. Connect the ﬂ ight battery in the quadcopter. The blue LED on the 5-in-1 control unit ﬂ ashes after 5 seconds.

8. Put the transmitter into bind mode while powering on the transmitter.

9. Release the bind button/switch after 2–3 seconds. The quadcopter is bound when the blue LED on the

5-in-1 control unit turns solid.

10. Disconnect the ﬂ ight battery and power the transmitter off.

CAUTION: When using a Futaba

throttle channel and re-bind. Refer to your Spektrum module manual for binding and failsafe instructions.

Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.

RTF

Your RTF transmitter comes prebound to the model. If you need to re-bind, follow the directions below.

MLP6DSM Binding Procedure

1. Disconnect the ﬂ ight battery from the quadcopter.

2. Center all trims on your transmitter.

3. Power off the transmitter and move the throttle stick to the down/off position.

4. Connect the ﬂ ight battery in the quadcopter. The LED on the 5-in-1 control unit ﬂ ashes after 5 seconds.

5. When the blue light is ﬂ ashing, push in and hold down the left stick* while powering on the transmitter

(you will hear a 'click').

6. Release the left stick. The transmitter will beep and the power LED will blink.

7. The quadcopter is bound when the LED on the 5-in-1 control unit is solid blue (not blinking).

8. Disconnect the ﬂ ight battery and power the transmitter off.

* The trigger switch may also be used for the binding procedure.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other instructions.

If needed, contact the appropriate Horizon Product Support ofﬁ ce. For a list of compatible DSM

visit www.bindnﬂ y.com.

transmitter with a Spektrum™ DSM2

/DSMX

module, you must reverse the

transmitters, please