Blade Scimitar LRX Buku Petunjuk - Halaman 9
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Drone Blade Scimitar LRX. Blade Scimitar LRX 13 halaman.
Halaman CetakTroubleshooting Guide
WARNING: Remove the propellers from the motors prior to performing any troubleshooting or maintenance. Failure to
do so may cause serious injury if the motors start unexpetedly.
Problem
Quadcopter control response is
inconsistent or requires extra
trim to neutralize movement
Quadcopter will not respond
to throttle
Quadcopter does not function
and smells burnt after
connecting the flight battery
Quadcopter has reduced flight
time or is underpowered
Crashes immediately upon
lift-off
Difficulty binding
Difficulty connecting
(after binding)
Static in FPV feed
Possible Cause
Quadcopter not initialized on a level surface
Battery not correctly placed
Motor arm switch is in the OFF position
Throttle too high and/or throttle trim is too high
Quadcopter moved during initialization
Throttle channel is reversed
Travel adjust settings not correct
Flight battery connected with the wrong
polarity
Flight battery charge is low
Inadequate power to flight battery charger
Flight battery is damaged
Flight conditions might be too cold
Propellers in wrong locations or incorrect flight
mode selected
Aileron, elevator or rudder are reversed in the
transmitter
Bind button not pressed while powering on
the quadcopter
Bind switch or button was not held while
transmitter was powered on
Transmitter too near aircraft during binding
process
Quadcopter or transmitter is too close to
large metal object, wireless source or another
transmitter
Transmitter not powered on before the
quadcopter
Less than a 5-second wait between first
powering on the transmitter and connecting
the flight battery to the quadcopter
The quadcopter is bound to a different model
memory (ModelMatch
transmitters only)
™
Flight battery or transmitter battery charge is
too low
Quadcopter or transmitter is too close to
large metal object, wireless source or another
transmitter
Interference on chosen channel
Flying too close to 5.8 GHz WiFi source
Disconnect the flight battery, center the control trim and
re-initialize the quadcopter
Adjust battery position so quadcopter balances in the
center of the frame
Set the motor arm switch to the ON position
Reset controls with the throttle stick and throttle trim at
the lowest setting
Disconnect the flight battery and re-initialize the
quadcopter while keeping the quadcopter from moving
Disconnect flight battery, reverse the throttle channel on
the transmitter, recconnect flight battery
Refer to the transmitter setup table for correct travel
adjust settings
Replace the power distribution board. Connect the flight
battery noting proper polarity
Completely recharge the flight battery
Use a different power source for the charger
Replace the flight battery and follow the flight battery
instructions
Make sure battery is warm (room temperature) before use
Ensure propeller direction and motor direction are correct
Ensure aileron, elevator or rudder are not reversed
Power off quadcopter and repeat bind process
Power off transmitter and repeat bind process
Power off transmitter. Move transmitter farther from
the aircraft or shield the aircraft from transmitter using
your body. Disconnect and reconnect flight battery to
quadcopter. Follow the binding instructions
Move quadcopter and transmitter to another location and
attempt binding again
Power off quadcopter. Power on transmitter then
quadcopter
Leave the transmitter powered on. Disconnect and
reconnect the flight battery to the quadcopter
Select the correct model memory on the transmitter.
Disconnect and reconnect the flight battery to the
quadcopter
Replace or recharge batteries
Move quadcopter and transmitter to another location and
attempt connecting again
Change the video transmitter and receiver channel per
the Using the Micro Camera section
Remove WiFi source or move to a different flying area
9
Solution
EN