Blade Vusion 250 V2 Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Drone Blade Vusion 250 V2. Blade Vusion 250 V2 18 halaman. Fpv-ready racing drone rtf

Halaman Cetak

Flight Modes

The quadcopter has 3 ﬂ ight modes accessible by changing

the ﬂ ight mode switch position.

Angle Mode: This mode has auto level, mild roll rates and

very limited tilt angles. Ideal for the pilot who is moving up

from an entry level quadcopter.

Horizon Mode: This mode still has auto level, but has

higher roll rates and a high tilt angle setting. This mode is

for more experienced pilots.

Acro Mode: This mode has no limits on tilt and faster roll

rates. The quad will not auto level in this mode. This mode

offers the most maneuverability but requires the pilot to be

able to control the attitude of the quadcopter.

Flying the Vusion 250

Motor Arming

Turn on the transmitter. Connect the ﬂ ight battery to the

aircraft. Place the quadcopter on a level surface and let it sit

for 10 seconds to let the ﬂ ight controller set up the gyros.

Set the dual rate switch to high. The motors will not arm if

the dual rate switch is in the low position. With the throttle at

its lowest setting, hold the yaw control (left stick) to the right.

The quadcopter will beep once to indicate the motors are

armed. Advance the throttle to start the motors spinning.

CAUTION: Any throttle input while the motors are

armed will cause the motors to spin. Always keep

body parts, clothing and loose items away from the propellers.

To disarm the motors, lower the throttle to the lowest setting.

Set the dual rate switch to high. Hold the yaw control to the

left until the quadcopter beeps, indicating the motors are

disarmed. The motors will also disarm if the throttle is at its

lowest setting for more than 5 seconds.

Flight Modes

Switch

Position

Angle Mode

Farthest

Horizon Mode

Middle

Acro Mode

Closest

It normally takes a week or two of practice to learn to ﬂ y

consistently in Acro Mode. Start by ﬂ ying line of sight (no FPV)

until you can comfortably control the quad. If possible, ﬂ y

in an open area over tall grass to minimize damage to the

aircraft when you crash. When you are comfortable making a

ﬂ ip in this mode, you should be ready for FPV.

Takeoff

With the motors armed and spinning, advance the throttle

slowly to take off. Increase the throttle until the model is

approximately 2 ft. (600mm) off the ground and check the

trim so the model ﬂ ies as desired. Once the trim is adjusted,

begin ﬂ ying the model.

Flight times for the included battery will vary according to

how aggressively the throttle is used.

Low Voltage Cutoff (LVC)

LVC decreases the power to the motors when the battery

voltage gets low. When the motor power decreases, land the

aircraft immediately and recharge the ﬂ ight battery.

LVC does not prevent the battery from over-discharge during

storage.

NOTICE: Repeated ﬂ ying to LVC will damage the battery.

Landing

To land, hover the aircraft over the landing spot and slowly

reduce the throttle. When the aircraft touches down, lower

the throttle fully.

To disarm the motors, lower the throttle to the lowest setting.

Set the dual rate switch to high. Hold the yaw control to the

left until the quadcopter beeps, indicating the motors are

disarmed. The motors will also disarm if the throttle is at its

lowest setting for more than 5 seconds.

Unplug and remove the battery.

Stability

Tilt

Roll

Mode

Angle

Rate

Stability

Low

Stability

Medium

Rate

Unlimited

High