Blade CG02+ 3-Axis Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kamera Digital Blade CG02+ 3-Axis. Blade CG02+ 3-Axis 17 halaman. Brushless camera/gimbal

Installing the Mounting Plate

The CGO2+ camera gimbal is compatible with

350 QX3 and Chroma

appropriate mounting plate using the 3 included

M2.5 x 10 screws. Do not overtighten.

IMPORTANT: If you are mounting the CGO2+ to the

350 QX3, you must ﬁ rst install the 350 QX3 tall

landing gear (BLH8105).

Install the gimbal by lining up the mounting rails of the

gimbal and the mounting plate and pushing towards

the rear of the plate as shown at left until it locks into

place.

To remove the gimbal, push in the retaining clip at

the front of the mounting plate and pull the gimbal

forward.

Connect the harness from the gimbal to either

the exposed wire harness from the 350 QX3 or

to the recessed plug in the bottom of the Chroma

quadcopter.

™

quadcopters. Install the