Discount Car Stereo A2DIY-CR12 Panduan Instalasi Mulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi Mulai Cepat untuk Sistem Stereo Mobil Discount Car Stereo A2DIY-CR12. Discount Car Stereo A2DIY-CR12 8 halaman. Bluetooth add-on module for porsche cr-1 and cr-2 radios

Halaman Cetak

Installation 2

Applies to vehicles with CD changer

CD changer must be in working order. If for some reason CD malfunctions,

the A2DIY-CR12 will not work.

Radio removal required to gain access to connectors.

Remove trim ring and ensure the 2 tabs are centered at which point the radio is

pulled out the dash (grasping the cassette opening provides some leverage) or

push from rear. Proceed with step 1 below

Disconnect factory 13-pin CD changer plug from radio

2. Connect factory 13-pin plug to module 13-pin connector (See Fig. 10)

3. Connect module 13-pin plug (See Fig. 9) to radio 13-pin connector vacated in

step 1 (See Fig. 2)

module 13-pin connector

4. Proceed to step 3 on page 3 to complete the rest of the installation

Fig. 9

Fig. 10

Optional charging port

This fast charge USB kit can be added to any vehicle. It supports BC1.2, QC2.0,

QC3.0, PE1.1, PE2.0, FCP, SFCP fast charge protocols (Apple, Samsung, Huawei etc.)

Note: iPhone "Fast charge" kicks in when battery capacity is between 0-79%, and

return to regular charge mode when it reaches 80%.

Should you decide to add to car, we suggest one of 3 connecting options:

A. Flush to dash/panel requires drilling a ¾" hole

B. Flush with Support bracket (Mount USB terminal wherever your installation

demands without drilling)

Flush to Dash or Panel

Drill a ¾" hole in the dash or panel using a step drill bit or equivalent

(See Fig. 11)

Step drill bit

2. Insert supplied 3ft. USB male terminal (See Fig. 12) through hole created

in step 1 and connect to install harness USB port (See Fig. 13)

(drilling required)

Fig. 11