Cub Cadet CC 2000 Panduan Operator - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemangkas Cub Cadet CC 2000. Cub Cadet CC 2000 20 halaman. 2-cycle trimmer
Juga untuk Cub Cadet CC 2000: Daftar Bagian (2 halaman)

Halaman Cetak

Section 4

Oil and Fuel

UNLEADED GAS

Cub Cadet 2 CYCLE OIL

1 US, GALLON

4,0 FL, OZ,

(3,8 LITERS)

(118 ml)

MIXING RATIO - 32:1

Fig. 4-1

0il and Gas Mixing Instructions

Old and/or improperly mixed fuel are the main

reasons for the unit not running properly. Be sure to

use fresh, clean unleaded fuel. Follow the instructions

carefully for the proper fuel/oil mixture.

Definitionof BlendedFuels

Today's fuels are often a blend of gasoline and

oxygenates such as ethanol, methanol or MTBE (ether).

Alcohol-blended

fuel absorbs water. As little as 1%

water in the fuel can make fuel and oil separate. It

forms acids when stored. When using alcohol-blended

fuel, use fresh fuel (less than 60 days old).

Using Blended Fuels

If you choose to use a blended fuel, or its use is

unavoidable, follow recommended

precautions.

• Always use fresh fuel mix per your operator's

manual.

• Always agitate the fuel mix before fueling the unit.

• Drain the tank and run the engine dry before storing

the unit.

Using Fuel Additives

The bottle of Cub Cadet 2-Cycle oil that came with

your unit contains a fuel additive which will help inhibit

corrosion and minimize the formation of gum

deposits.It is recommended

that you use only

Cub Cadet 2-Cycle oil with this unit.

If unavailable, use a good 2-cycle oil designed for

air-cooled engines along with a fuel additive, such as

STA-BIL® Gas Stabilizer or an equivalent. Add 0.8 oz.

(23 ml) of fuel additive per gallon of fuel according to

the instructions

on the container. NEVER add fuel

additives directly to the unit's fuel tank.

For proper

engine operation

and maximum

reliability, pay strict attention to the oil and fuel

mixing instructions

on the 2-cycle

oil container.

Using improperly

mixed fuel can severely

damage the engine.

Thoroughly mix the proper ratio of 2-cycle engine oil

with unleaded gasoline in a separate fuel can. Use a

32:1 fuel/oil ratio. Do not mix them directly in the

engine fuel tank. See Figure 4-1 for specific gas and oil

mixing ratios.

NOTE: One gallon (3.8 liters) of unleaded gasoline

mixed with one 4 oz. (118 ml) bottle of Cub Cadet

2-CYCLE OIL makes a 32:1 fuel/oil ratio.

Gasoline is extremely

flammable.

Ignited Vapors

may explode. Always stop the engine and allow it

to cool before

filling

the fuel tank.

Do not smoke

while filling

the tank.

Keep sparks and open

flames

at a distance

from the area.

Remove fuel cap slowly to avoid injury from fuel

spray. Never operate the unit without the fuel cap

securely in place.

Add fuel in a clean, well ventilated

area outdoors.

Wipe up any spilled fuel immediately.

Avoid

creating a source of ignition for spilt fuel. Do not

start the engine until fuel vapors dissipate.

NOTE: Dispose of the old fuel/oil mix in accordance

to Federal, State, and Local regulations.