Discount Car Stereo A2DIY-CHRY02 Panduan Instalasi Mulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi Mulai Cepat untuk Aksesori Mobil Discount Car Stereo A2DIY-CHRY02. Discount Car Stereo A2DIY-CHRY02 7 halaman. Chrysler cd changer controlling radios

Halaman Cetak

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

•

This installation guide is provided as a GENERAL installation guide, some vehicles vary and

may require additional steps. We do not accept responsibility for third party labor charges

or modifications. Exercise due-diligence when installing this product.

•

We do not accept any responsibility for vehicle damage or personal injury resulting from

the installation of this product.

Careless installation and operation can result in equipment damage

•

Requirements:

CD CHANGER CONTROLLING RADIO

Introduction –

newest version 6.9

The A2DIY-CHRY02 wirelessly connects mobile devices to Chrysler radio system

allowing for Smartphone hands-free calls, music streaming, turn-by-turn

navigation, and more. A wireless connection means no wires, clutter or

complicated setup. The A2DIY-CHRY02 solution connects to the 10-pin CD

changer/Sat radio port which guarantees to best possible sound. In addition to

Bluetooth, users can also connect and play other devices through the module

AUX input jack and use included media remote to switch between sources, adjust

volume, change tracks, answer/end calls and more.

See Frequently Asked question at the end of this guide for details.

If installing module purchased prior to 6/9, click here.

Installation

Radio must be removed from dashboard to gain access to the connectors.

Vehicle specific radio removal is not part of this guide; however, they are

available upon request.

With radio out;

Connect harness 10-pin plug (See Fig. 1) to radio 10-pin connector, (See Fig.

Any factory option (satellite radio, CD changer etc.) plug already in place,

must be permanently disconnected.

Fig. 1

10-pin plug

Fig. 2

Radio 10-pin connector

Connect included 3.5mm male-male cable (See Fig. 5) to module "AUX"

input jack (See Fig. 6), and route audio cable to where audio device will

reside (within 3 ft.,)

Fig. 5