Cub Cadet 19A40002100 Panduan Operator - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Operator untuk Aksesori Mesin Pemotong Rumput Cub Cadet 19A40002100. Cub Cadet 19A40002100 20 halaman. Triple rear bagger

Halaman Cetak

Attaching Blades

WARNING!

servicing blades by wearing heavy work gloves or

using heavy rags.

NOTE: High-lift bagging blades are included in the grass-catcher

kit. Replace the blades with these new blades and save the

existing blades as replacements or to reinstall on the blade

spindles when not using the bagger kit.

Remove cutting deck from beneath the tractor following

instructions for Deck Removal in operator's manual of the

tractor. Gently flip the deck over to expose its underside.

Place a block of wood between the center deck housing

baffle and the cutting blade to act as a stabilizer. See

Fig. 4-16.

Hex Flange Nut

Spindle Assembly

Use a 15/16" wrench to remove the hex flange nut that

secures the blades to the blade spindle assemblies. See

Fig. 4-16.

WARNING!

thread pattern. Do not attempt to force the nut in

wrong direction; it may damage the nut and create a

safety hazard.

Place a new blade on each spindle so that side of the blade

with part number faces the ground when the mower is in

the operating position.

Note: This bagger kit includes two sets of blades, one set is

for the 50" deck and the other is for the 54" deck. Based on

the deck that you have, install one of the following blade

sets. The blades can be identified by the part number

stamped on each blade:

• 50" Mowing Deck, install Part No. 742-04056C

• 54" Mowing Deck, install Part No. 742-0679

Secure with the hex flange nut removed earlier. Use a

torque wrench to tighten the hex flange nut between 70 to

90 foot-pounds.

4 — a

ectiOn

sseMbly

Always protect your hands while

Wood Block

Figure 4-16

The hex flange nut has a right-handed

& i

nstallatiOn

Move the wood block to either the left or right blade for

stabilization and remove and replace the center blade so

that side of the blade with part number faces the ground

when the mower is in the operating position.

NOTE: Save the three blades you just removed to use as

replacements or to reinstall on the blade spindles when not

using the bagger kit.

Installing the Deck Baffle

Note: If the deck is still flipped upside down with the blades

exposed, it may be easiest to flip the deck back over to complete the

following installation of the deck baffle and chute stop bracket.

Remove two of the self-tapping deck screws on the front

right side of your deck.

Install the front deck baffle using the hardware pack 689-

00163 included with this bagger kit. See Fig. 4-17.

Note: This bagger kit includes two deck baffles, one baffle is

for the 50" deck and the other is for a 54" deck. Based on the

deck that you have, install one of the following baffles using the

directed hardware. The baffles may be identified by looking at

the parts list on Page 16:

•

50" Mowing Deck, install deck baffle Part No. 703-05783

using two 710-3015 1/4-20 hex bolts and 712-04064 1/4-20

flange lock nuts.

•

54" Mowing Deck, install deck baffle Part No. 703-06018A

using two 710-04484 self-tap hex bolts.

Hex Nut

Deck Baffle

Hex Bolt

50" Deck

Figure 4-17

54" Deck