Arnica 1449 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penyedot Debu Arnica 1449. Arnica 1449 12 halaman. Water filter vacuum cleaner

Halaman Cetak

IV. PREPARING FOR USE

• ATTENTION – Do not insert the mains plug into the wall socket until

the appliance is completely ready for use.

• Lift up the Motor Unit using the handle provided, take the attach-

ments out of the container.

• When unpacking, please check that all parts are included and

undamaged.

• Keep the accessories for further uses.

• Make sure that foam filter is fixed on the float case.

• Install the wheels onto the container bottom.

• Install the water filter tube.

• Locate the water filter body.

• Put the water filter sponges into the nests.

• To connect the hose, insert it into the suction inlet.

IV. OPERATING THE APPLIANCE

• Always be sure that the mains plug is removed from the wall socket.

• Make sure that the container, tubes and hose group are dry and

clean.

• Unlock the clamps and lift the motor unit upside down.

• Do not use the appliance without the foam filter.

• Lift up the motor unit

• Remove the water filter body and fill container with clean water

(Max. 2 lt). Replace water filter body.

• Put the motor unit back onto appliance and lock the clamps.

• Fit the cleaning accessories most suited to the type of operation to

be performed, on to the suction tubes or directly in to the handgrip.

• For effective cleaning the following accessory can be used.

» Nozzle (C7) for removing dust from carpets, mats and hard floor

surfaces.

» Crevice nozzle (D2) for cleaning narrow corners and hard to

reach places

» Directly suction tube (C5) for sucking soil, shavings, crumbs,

fluff.

» Small Nozzle (D4) and the suction tube for removing dust from

shelves, books, lamp shades, frames, ornaments, curtains,

clothes, electronic equipment's, surfaces.

• Pull the mains cord out of the appliance and insert the mains plug into the

wall socket. Push the On/Off Button (A1) to switch the appliance on.

BLOWING FUNCTION

The appliance has blowing function. You may have use this function to

dry something or clean the clogged washbasin and bathtub. Connect

suction hose to the Hepa Filter Housing Cover (A4) then switch on

appliance. To clean the clog washbasin and bathtup you may use round

nozzle (D3) after detaching its brush.

V. CLEANING AND MAINTENANCE

• Always switch the appliance off and remove the mains plug from the

wall socket before starting any maintenance or cleaning operations.

• Always empty, clean and dry the container after use.

• To ensure perfect hygiene and length the working life of vacuum

cleaner, never leave wet and dirt inside the container.

• Before emptying dirt and waste liquid remove suction hose and lift

motor unit by pulling the clip locks.

• The foam filter can be washed warm, soapy water or running water.

Dry it throughly before planing on to float case. Don't wash foam

filter at washing machine with hot water.

• Clean and check the float valve inside the float case moves freely in

it's housing. For checking the float, lift up the Motor Unit and shake

it.

• The cleanness of hepa filter should be checked periodically. Clean

the filter if it is not clean. This filter loses its characteristics after a

certain usage period and requires replacing.

This appliance is not intended for use by persons (including chil-

dren) with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by

a person responsible for their safety.

Children should be supervised to ensure that they do not play

with the appliance.