abbexa abx725008 Panduan Produk - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Produk untuk Pengaduk abbexa abx725008. abbexa abx725008 7 halaman. Mini vortex mixer

Product Manual

• Personal protective equipment (PPE), such as lab coats, disposable gloves and eye

protection, should be used.

• Turn off the device and unplug the power supply plug at the mains.

• Using 75% alcohol disposable wipes, clean the external surface of the apparatus.

• Wait for the instrument to fully dry before reconnecting the power supply.

4.3 Routine maintenance

• Only use a cloth with water, mild soap or a non-abrasive cleaning liquid (pH 6 – 8) to

clean the instrument. Using abrasive reagents may damage the instrument.

• If any reagents or any corrosive substances are spilled on the instrument, immediately

wash with a wet cloth and water.

• The exterior of the equipment should be cleaned regularly and at least on a monthly

basis.

• Good operating practice may extend the life of the product.

The table below lists some common problems

encountered when using the instrument. If the problems are

still not resolved after following the suggested solutions,

please contact a service engineer.

Issue

The device is only

partially working.

Device will not start.

Device is running

continuously

without touch start.

Table 1. Troubleshooting table

www.abbexa.com · Email: [email protected] · Phone: +44 (0) 1223 755950 · Fax: +44 (0) 1223 755951

Possible causes

Small screw in the

bottom may be

loose.

Small screw in the

bottom may be

loose.

Small screw in the

bottom may be

too tight.

Abbexa Ltd., Cambridge Science Park, Cambridge, CB4 0EY, UK

Registered in England: 8475531 · VAT Reg. No: GB 167 9240 79

Solution

Tighten by ½ or 1 turns.

Tighten by 1-2 turns.

Loosen by 1-2 turns