Arnott P-2932 Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kompresor Udara Arnott P-2932. Arnott P-2932 5 halaman. Air suspension compressor ford expedition/lincoln navigator
Halaman Cetak
GENERAL INFORMATION:
Reading this manual signifies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
•
Not to be stored below 5
•
Avoid damage to air lines and cables.
•
Removal and installation is only to be performed by fully qualified personnel.
•
Use car manufacturer's diagnostic software.
CAUTION: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specified
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
AIR SUSPENSION COMPRESSOR REMOVAL
1.
TURN THE AIR SUSPENSION SWITCH TO THE OFF POSITION. (REFER TO THE OWNER'S MANUAL FOR
SWITCH LOCATION).
2.
OPEN THE HOOD OF THE VEHICLE.
3.
UNBOLT AND REMOVE THE WINDSHIELD WASHER RESERVOIR TANK TO GAIN ACCESS TO THE COMPRESSOR
ASSEMBLY. (FIGURE 1)
2
P-2932
ARNOTT AIR SUSPENSION COMPRESSOR
FORD EXPEDITION/LINCOLN NAVIGATOR
CHASSIS: UN173 2WD/4WD, U228
o
o
o
F (-15
C) or above 122
-2932
P
o
F (50
C).
FIGURE 1
REV 3
02/21/2018