ARO 8475-A- Panduan Operator

Jelajahi secara online atau unduh pdf Panduan Operator untuk Penggiling ARO 8475-A-. ARO 8475-A- 12 halaman. “000-1” series

Halaman Cetak
OPERATORS MANUAL
a-
SECTION
MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
"0004"
SERIES GRINDERS
Released: 10/72
Revised:
3-l0-95
Form:
006-2
Tool Products
Models:
8475-A-(
), 8475-A1,
8476-A,
8476-A1,
8477-A,
8477-A1,
8478-A and 8478-A1.
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
To aid the operator's understanding of proper and safe use of
grinders, the publications, "Use, Care and Protection of Abrasive
Wheels", A.N.S.I. 87.1, and "Safety Code for Portable Air Tools",
A.N.S.I. 8188.1, can be purchased from:
American National Standards Institute, Inc.
1430 Broadway
New York, New York 16018
Operate this tool at 90 p.s.i.g. (8.2 bar) maximum air pressure
at the air inlet of the tool.
Disconnect air supply from tool before removing/installing
grinding wheel, wire brush or performing other maintenance
procedures.
Keep hands, clothing and long hair away from rotating end of
tool.
Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool.
Tool shaft can continue to rotate briefly after throttle is re-
leased.
Do not lubricate tools with flammable orvolatile liquids such as
kerosene, diesel or jet fuel.
Use tool only for purposes for which it was intended.
l
Do not use excessive work pressure.
l
Do not remove any labels. Replace any damaged label.
l
Use only accessories recommended by ARO.
Repeated prolonged operator exposure to vibrations which may
be generated in the use of certain hand-held tools may produce
Raynaud's phenomenon, commonly referred to as Whitefinger
disease. The phenomenon produces numbness and burning
sensations in the hand and may cause circulation and nerve dam-
age as well as tissue necrosis. Repetitive users of hand-held
tools who experience vibrations should closely monitor duration
of use and their physical condition.
The use of other than genuine ARO replacement parts may
result in safety hazards, decreased tool performance and in-
creased maintenance and may invalidate all warranties.
ARO is not responsible for customer modification of tools for
applications on which ARO was not consulted.
Tool maintenance and repair should be performed by autho-
rized, trained, competent personnel. Consult your nearest
ARO authorized servicenter.
It is the responsibility of the employer to place the information
in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution
Center, White House, TN at PH: (815) 672-0321, FAX: (615) 672-0601.
ARO Tool Products
Ingersoll-Rand
Company
1725 U.S. No. 1 North
l
PO. Box 8000
l
Southern Pines, NC 283888666
Part of world wide Ingersoll-Rand