Cube RAW Split Panduan Perakitan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Perabotan Dalam Ruangan Cube RAW Split. Cube RAW Split 5 halaman.

Assembly manual for RAW Split

Place the two plates on a secure backing face down. Assemble the frame upside down on top of the plates. Mount

the frame when it is completely assembled.

IMPORTANT: It is important that the frame is completely assembled before it is mounted on the plates, as the width

of the frame can fluctuate a few millimeters in length. The plates have 2 pre-drilled holes where the rest of the screws

are mounted through guiding lines. It is important to follow the guide carefully when mounting the the frame.

Assemble the frame as follows:

Step 1: Place the two special slide rails on the plates. The slide rails are assembled from our production and there is

a right and left rail.

NOTE: Place the slide rails correctly. The low side of the rail should face the side of the table and the high side with 4

holes should face the center. There should also be two holes in the rail facing the smallest table plate as shown in the

last picture above.

Step 2: Place the two rails and the two columns between the sliding rails.

Now it is time to mount the frame, follow the order on the next page.

CUBE

D E S I G N

Cube Design A/S

Vadstedvej 212 | DK-8450 Hammel | Tlf./Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]