3D Hobby Shop Velox VR-1 Panduan Perakitan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mainan 3D Hobby Shop Velox VR-1. 3D Hobby Shop Velox VR-1 17 halaman.

Attach a 12" inch / 300mm servo extension to the elevator servo. Use heat-shrink tubing or a servo-plug

lock on this connection. Install the elevator servo into the fuselage as shown. Install the pushrod adjustor

onto the servo arm. As before, do not fully tighten this nut, the adjustor must be able to rotate. Use thick

CA glue to lock this nut. After installation, the pushrod may be trimmed to length.

NOTE: Again, if you are unsure of the exact length of servo arm necessary, you can leave the adjustor

screw unlocked until after you have made sure your servo arm length is correct. Details of this will be

covered in the control setup section of the manual.