3D Hobby Shop Extra SHP 47" Panduan Perakitan - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Pesawat terbang 3D Hobby Shop Extra SHP 47". 3D Hobby Shop Extra SHP 47" 20 halaman. Arf rc

Halaman Cetak

Install elevator horn, servo, arm, and pushrod on the LEFT side of the aircraft using the same procedure

as the rudder components. The elevator pushrod is the 2

longest in your kit. The elevator pushrod will

require a slight bend near the servo for alignment.

Assemble your brushless motor for mounting *in front of* the firewall (many brushless motors have more

than one mounting option). Mount the motor to the firewall as shown using the 4 longer 3mm allen-head

screws in your kit. If you are using the recommended motor, you will need to use the 4 white nylon motor

spacers included in your kit. Use blue Loctite on these screws.

Attach your speed controller to the side of the motor box with plastic Zip-ties or Velcro.

The motor and the speed control are connected together with 3 wires. If you need to reverse the direction

of rotation of your brushless motor, disconnect and switch any two of these wires.

NOTE: NEVER RUN YOUR MOTOR WITH A PROP INSTALLED INDOORS OR ON YOUR

WORKBENCH. DO NOT INSTALL YOUR PROP UNTIL YOU ARE PREPARED FOR AN OUTDOOR

TEST.