3D innovations DeskCycle Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sepeda Latihan 3D innovations DeskCycle. 3D innovations DeskCycle 16 halaman. Using the large display manual
Juga untuk 3D innovations DeskCycle: Panduan Pemilik (12 halaman), Manual (3 halaman)
Halaman Cetak
Some people prefer to use the bike without the pedals straps. When the pedal straps are removed the
top of the pedal will always face up. This makes it easier to quickly place your feet on the pedals.
•
The top and bottom pedal halves snap together.
•
You can remove the straps whether the pedals are attached to
the bike or not.
Follow the steps below to remove the straps.
Step 1:
Insert a flat screwdriver into one of the slots. Rotate the
screwdriver downward to pry the halves apart. You should hear
a slight pop as one of the snap-fittings comes loose. There are 4
snap-fittings holding the pedals together.
Step 2:
Insert the screwdriver into the 2nd slot and repeat step 1.
Step 3:
Now insert the screwdriver into the gap on the side of the pedal.
Twist the screwdriver to pry the halves apart.
Step 4:
Slide the screwdriver to the right and twist again. Repeat until you
hear the snap-fitting release.
Repeat steps 3 and 4 on the other side of the pedal.
At this point you should be able to pull the halves apart.
Step 5:
The straps are pressed onto the posts as shown in the picture on
the right. Just pull up on the ends of the straps to remove them.
Step 6:
Press the halves back together.
Removing the Pedal Straps
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
9