DiscreteHeat ThermaSkirt Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pemanas DiscreteHeat ThermaSkirt. DiscreteHeat ThermaSkirt 12 halaman. Discreteheat thermaskirt room heating system

Halaman Cetak
2 .
C UT TI N G S KI RTI NG TO LENGTH ( w hen no t s u ppl i ed pre-cu t)
COMMON CUTTING ALLOWANCES (note number and configuration of clips)
120mm (5")
1x clip at back
TRV Feed/return
Offer the flexible coupling up
centrally to the internal corner and
mark the wall at this point to give
the cut length of skirting
=
=
Push into corner
2x clips at front
Odd angle - internal
IMPORTANT:
All cut ends MUST be deburred to preserve your warranty.
Remove all chaff and debris to preserve your warranty. Problems may occur
if not properly removed.
IMPORTANT - ALL CUT ENDS MUST BE DEBURRED AS SHOWN BELOW
DEBURR!
Tel: 0845 1238367
TM
40mm
20mm
1x clip at back
Internal corner
Avoid chafeing
on the corner
Offer flexible coupling up centrally
to the external corner and
mark the wall at this point to give
the cut length of skirting
Odd angle - external
Deburring tool
(Part No. STOOL)
Keep parallel
Fax: 01942 665104 e-mail: [email protected] web: www.discreteheat.co.uk
I N S T A L L AT I O N
0~3mm (0.0")
2x clips at front
External corner
=
=
2x clips at front
1x clip at front, 1x clip behind
In-line joint (> 6m walls)
'Bell Mouth'
deburr
50mm (2")
1x clip at front (or back)
Non TRV feed & return /
Return manifold
20mm (0.8")
length = 55mm (2.16")
Remove all chaff
and debris
Page 3
100mm (4")
1x clip at front
threshold kit
115mm (min)
1x clip at front
Door architrave kit
Minimum active
!