3D Nord magicolor 2300W Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D Nord magicolor 2300W. 3D Nord magicolor 2300W 19 halaman.

Pressing on the transfer belt unit

with one hand, take the tag

attached to the transfer belt unit

fixture with your other hand, and

pull the fixture straight toward you.

This fixture protects the transfer

belt during initial transportation.

! "

Dispose of the fixture

according to your local

regulations.

Insert the waste toner bottle.

Insert the bottom of the waste

toner bottle $ into the printer.

b Push the top of the waste toner

bottle % into position so it is

firmly seated.

If the waste toner bottle is not

correctly installed or the transfer

belt release lever is at its top

position (11 o'clock), the front

door cannot be closed.

Close the front door.

Installing the Tray 1 Media Support

Remove the media support from its

plastic shipping bag, and then attach

it to Tray 1.

Insert the three tabs $ on the media

support into the three holes in Tray 1,

and then lower the two tabs % into

their corresponding holes below Tray

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

$ $ $ $

% % % %

Setting up Your Printer