AromaMist AI-5 Panduan Instalasi dan Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pompa Air AromaMist AI-5. AromaMist AI-5 15 halaman.

Start-Up -

CAUTION: Please read all 7 steps prior to priming the

pump

AromaMist

1. Insert

AromaMist

2. Insert

3. Power up integral

face. Switch LED will light when on.

4. Initiate the remote-mounted aroma switch by pressing gently on jet icon.

Aroma LED will light when on and pump will start moving aroma oil.

AromaMist

5. With

pump panel face. This will initiate the priming process where aroma oil will be

drawn at a faster rate to fill the suction and discharge tubing. Releasing prime

button will stop priming process.

6. With pump in priming mode, if fluid begins moving up suction tubing without

hesitation, bleed valve adjustment is not required. If fluid is not moving up suction

line, open bleed valve (counter-clockwise) approximately one (1) turn or until fluid

begins to move. When fluid level reaches the pump head assembly, close bleed

valve allowing fluid to flow through pump head and up to the steam line. NOTE:

Do not over tighten bleed valve as damage may occur.

7. Once aroma oil has reached the 3-function valve, release the priming tubing

and turn off the remote-mounted aroma switch.

for use.

NOTE: Pump integral On/Off rocker switch must stay in the on position to

operate pump from remote-mounted aroma switch.

AromaMist

Primimg the

pump power supply cord into pump power supply module.

pump power supply module into grounded 110V AC outlet.

AromaMist

pump rocker switch located on the pump panel

pump on, push and hold the priming button located on the

Page 11

pump

AromaMist

pump is now ready