3D R DIY QUAD Panduan Perakitan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Pesawat terbang 3D R DIY QUAD. 3D R DIY QUAD 12 halaman.

Connect power module to PDB

Connect power module 6-position cable to the power module 6-position port. Place power

module in the center of your copter near the PDB. Connect PDB red and black cable (with yel-

low XT60 connector) to power module XT60 connector.

Power module with 6-wire cable

IN STA LL APM

Mount APM

Place the APM 2.6 in the center of the APM plate

with the arrow on the case facing as shown.

Use the mounting foam to secure the APM

to the plate.

Ensure mounting tape is firmly attached so the position of the APM doesn't shift during flight.

For APM 2.5: Mount the APM to the top of the accessory plate.

For plus configuration: Mount the APM with arrow pointing toward blue arm.

Connect APM to power module and PDB

Connect the power module six-position cable (red and black) to the APM PM port. Connect the

PDB four-wire cable (multicolored) to the APM Outputs signal pins (top row). Ensure that the

wire originating in the position on the PDB pins labeled M1 connects to the APM Output signal

pin labeled 1, the M4 wire connects to position 4, etc.

PDB to APM wiring

PDB wire

positions

APM output

pin positions

Ensure arrow on APM

points forward!

3DR APM 2.6

PDB

APM plate

Power module