3D Robotics RTF-Y6 Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Drone 3D Robotics RTF-Y6. 3D Robotics RTF-Y6 8 halaman.

Halaman Cetak
4

Flight modes

Your copter's flight modes determine how it will behave in
the air. Select a flight mode using the two-position switch
and the three-position switch on the RC transmitter.
two-position
three-position
switch
switch
Spektrum
The three-position switch has the available positions forward (away
from you), center, and back (towards you). The two-position switch
has the available positions forward and back. Both switches must be
set to the correct position to select a mode.
Stabilize mode
Stabilize is your copter's manual flight mode. It
allows full manual control of altitude, position,
and orientation without autopilot assistance.
Use stabilize for acrobatic flying and to recover
your copter.
Loiter mode
In loiter, the autopilot automatically controls
altitude, position, and orientation. Just release
the sticks and the copter will hover in place.
Loiter is the easiest way to fly.
Altitude hold mode
Altitude hold mode maintains altitude
automatically. Set the left stick to center, and
the copter will hover at the current altitude.
Adjust altitude and orientation with the left
stick, and navigate with the right stick.
three-position
switch
FlySky
Stabalize
Stabalize
Altitude Hold
Altitude Hold
Loiter
Loiter
Full Autonomy
Full Autonomy
Return to Launch
Stabalize
Return to Launch
Altitude Hold
Loiter
two-position
switch
position of switch:
forward/forward
forward/back
X
no GPS lock required
GPS
position of switch:
center/forward
GPS lock required
GPS
before takeoff
position of switch:
center/back
X
no GPS lock required
GPS
If you did not order
an RC transmitter
with your copter,
visit
3dr.com/learn
for instructions.