Acoustic Class D NEO Dymium Series Panduan Pemilik - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Acoustic Class D NEO Dymium Series. Acoustic Class D NEO Dymium Series 16 halaman. Bass amplifiers
Halaman Cetak
pad
acousti-comp overdrive
clip
input
gain
BASS AMPLIFIERS OWNER'S MANUAL
SERIAL NO.
USE ONLY WITH A 250V FUSE
DESIGNED IN THE USA
AC 120V ~ 60Hz 330W
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
Fuse: T3.15A L 250V
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
1
B300HD BACK PANEL
1. AC Power Connection and Fuse: Connect included IEC power cable here. Fuse cap contains fuse for circuit protection
2. Power: Turns the amplifier on to ready for use
3. Speaker Outputs : 1/4" speaker jack and locking-barrel type jack for attaching external speakers (minimum 4 Ohm total load)
4. Link Out: Output to another Acoustic™ bass head. Allows user to run the B300HD in Master Mode to control another amp head.
This allows the user to link 2 heads together for more power and speakers controlled from one master amplifier
5. Link In: Input from another Acoustic™ bass head. Allows user to run the B300HD in Slave Mode controlled from another amp
head. This allows the user to link 2 heads together for more power and speakers controlled from one master amplifier
6. Effects Send: 1/4" two-conductor jack sends signal to an external effects or signal processing device
7. Effects Return: 1/4" two-conductor jack returns signal from an external effects or signal processing device
8. Footswitch: 1/4" Tip/Ring/Sleeve jack for attaching optional 2 button latching footswitch. Controls Overdrive on/off and
effects loop on/off
9. Tuner Send: Attach electronic instrument tuner via 1/4" 2 conductor instrument cable
10. Direct Output: XLR direct balanced output connector jack for connection to external PA or direct box
11. Pre/Post EQ Switch: Switches direct balanced output between pre and post EQ operation
12. Level: Adjusts the level of the direct output signal
13. Ground Lift: Lifts the ground from the XLR direct output. Useful for eliminating hum when the direct out is used
8
www.acousticamplification.com
mute
super-lo
overdrive
blend
50
3
minimum 4 O load
power
speaker
out
Made in CHINA
E467047
2
3
super-hi notch enable
120
350
800
3.2k
4
6
link out
effects send
link in
effects return
B300HD
www.acousticamplification.com
5
7
notch
master
aux in
B300HD
8
10
direct output
footswitch
tuner send
eq post
ground
pre
level
lift
9
11
12
13