3D Systems CUBE Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer 3D 3D Systems CUBE. 3D Systems CUBE 20 halaman. Replacing the print tip
Juga untuk 3D Systems CUBE: Dokumentasi (8 halaman), Pelajaran (15 halaman)
Halaman Cetak
At Cubify.com you can:
Upload your creations
Purchase creations
Get your creations 3D printed and shipped to you
Engage with other creative partners
Buy the Cube 3D Printer, print cartridges, and supplies
COPYRIGHT INFORMATION
©2015 by 3D Systems, Inc. All rights reserved. This document is subject to change
without notice. This document is copyrighted and contains proprietary information
that is the property of 3D Systems, Inc. The 3D Systems logo, 3D Systems, Cube
and Cubify are registered trademarks of 3D Systems, Inc. Use of the Cubify.com
website constitutes acceptance of its Terms of Service and Privacy Policy.
Compliance
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications to this equipment not specifically approved
by 3D Systems may void the user's authority to operate this equipment.
KCC
이 기기는 가정용(B급) 전자파적합기기로서 주 로 가정에서 사용하는 것을 목적으로 하며, 모 든 지역에서 사용할 수 있습니다.
This equipment is home use (Class B) electromagnetic wave suitability equipment