Aerial AD 110 Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Dehumidifier Aerial AD 110. Aerial AD 110 13 halaman. Aerial ad 110 dehumidifier instruction manual
Halaman Cetak
5.Operation
5.1 electrical connection
Before connecting the air dryer, the following items must be checked:
Does the mains voltage coincide with the voltage of the appliance?
Adequate fusing of socket and supply system?
Has the required residual-current-operated circuitbreaker (r.c.c.b) been installed
in case of swimming baths?
If a cable drum is used: has it been unwound completely?
Is the appliance connector suitable for the building socket?
Is the socket provided with a perfect grounding?
ATTENTION:
Before putting the air dryer into operation, the technical data of the appliance should
be compared to the conditions prevailing in the room of installation!
5.2 Putting into operation
ATTENTION:
Before putting the air dryer into operation, the instruction manual should be studied
carefully. Thus, damages by a false or inappropriate operation as well as by
inadequate environmental conditions can be avoided.
For using the air dryer, please proceed as follows:
After having been transported, the air dryer should rest for abt. 15 min. During
this period of time, the oil distributed inside the refrigerating system and frothed
during transport will return into the compressor. We recommend this procedure
since it extends the service life of the compressor.
Make sure that a socket and a runoff is near the installation place. When using a
device without pump (standard), the runoff must be placed below the unit.
Attach mounting bar to the planned wall (see rough draft point 4). Arrange with
spirit level!
Put up device on the mounting bar. Above the device is right and left in each
case a screw. With these screws, the device is to be fixed on the mounting bar.
Connect the available hose to a runoff. Guarantee that the hose is attached
certainly to the drain and can not slip. If the hose length should not be sufficient,
extend the hose with a nipple and two clamps. (accessory). Test for tightness!
The hose must be moved away with slope of the device. The hose must not be
buckled.
Put the plug into the socket.
Switch on the unit at the hygrostat. You find the hygrostat in the front.
Adjust the required humidity value at the hygrostat. (see hygrostat-control).
Is the actual humidity higher than the required value, the dehumidifier will start.
Is the actual humidity lower than the required value the dehumidifier will not start.
page 6 of 13