Aerial AD 430 Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Dehumidifier Aerial AD 430. Aerial AD 430 16 halaman.

This cleaning is without fail regularly required!

During construction site effort, after every effort or once a week!

No other maintenance work is required for the air dryer.

10. Trouble shooting

Assign that dehumidifier a putative defect on, please, first check the following points.

If this should provide no relief, please contact your technical consultant.

1)The dehumidifier shows a bad or no drying capacity

- The humidity is lower than 40% r.h. or the temperature in that room is lower than

+3° C. The using of the dryer is uneconomical in the case of these conditions. It is

recommended to disconnect the dryer. Tipp: Put the built-in hygrostat on an

attainable value (e.g. approx. 50%r.F.), with it the dryer punctually may switch off.

- The air filter is soiled. The dryer does not receive air sufficiently. Clean the filter

and/or install a new one. A soiled air filter can in the long run lead to

disadvantages at the dryer. Tipp: Control the filter regularly. Do only use original

air filters!

2) The fan of the dehumidifier does not work, the compressor still turns.

- At AD 430: The unit is in defrost mode. In this case the compressor still runs and

the fan does not run. After some minutes, the unit will start with regular working.

3) The compressor of the dehumidifier does not work, the fan still turns.

- At AD 420: The unit is in defrost mode. In this case the fan still runs and the

compressor does not run. After some minutes, the unit will start with regular

working.

4) The complete dryer is out of operation. Fan and compressor does not run.

- Is the dryer switched on? The On-/Off-switch must be in position `I´ and must light

up.

- Is the unit supplied with voltage? The On/Off-switch must light up in Pos. `I´.

Check the main cable, an additional cable, the socket and the main fuse.

- The humidity value adjusted at the hygrostat is achieved. The dryer will start again

after exceeding the adjusted humidity.

- Water collecting bucket is full: The red neon lights up (see 6.3 „operation panel").

Empty the water bucket and put it back into the unit. (see 6.5 „condensate outlet")

- The AMP-blind-plug is not fixed in the AMP-socket or a pump-out-kit is not

installed correctly. (see 6.6 „condensate pump")

5) Strong icing up at the evaporator.

- Put the dryer into a room with min. +10° C room temperature and wait until

complete ice is defrosted. Switch on the unit again (in that room with min. +10° C)

and let work for approx 3 hours. If there is icing up again, please contact your

dealer. Otherwise make sure that the unit is only been used in rooms with more

than +3° C. Also the storage of the dehumidifier at inadmissible temperature

conditions can lead to damages / problems while immediate switch-on.

page 14 of 16