Displays2go IPPROEVRF Panduan Pengguna
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Rak dan Dudukan Displays2go IPPROEVRF. Displays2go IPPROEVRF 2 halaman.
Halaman Cetak
User Manual
Thank you for ordering 2-in-1 floor and table tablet kiosk stand. Let's start setting it up!
Parts you will find
Aluminium Plate
Bended tube
Acrylic Cover
Long Screw"a" 8pcs
Short Screw"b" 4pcs
Flat end Screw"c" 4pcs
Acrylic Corner
Screwdriver
hexagon end 1pc
Before assembling please prepare the extension cable if you want power routing
through stand. Cable not included
Step1
Base and Straight Tube Connection
Please remember to insert cable when install if need power routing.
Locate the pole as above picture
The lock point face to the handle
Base & Pole upside down
Straight tube
Base
Spline end 1pc
4pcs Flat end screws"c" to tighten
and insert cable
Turn and put on floor
Counter clockwise tightening the screw
using Hex end screwdriver
Step2 Straight Tube and Bended Tube Connection
Insert the bended tube Remember Counter clockwise tightening
feed the cable to the bended tube
the screws of both sides using Hex end screwdriver
Step3
Connect the Aluminium Plate to
the Bended Tube using 4pcs Screw "b"
using Spline end screwdriver
Counter clockwise tightening
the screw of another side
Ready for next step
Step4
Connect 4pcs Acrylic corners to
the Aluminium Plate using 4pcs Screw"a"
Corner A at A position,
Corner B at B position,
Corner C at C position,
Do not fully tighten all
screws!
Need to adjust in next step.