Displays2go INTWHITWRLS Panduan Pemecahan Masalah - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah untuk Papan tulis Displays2go INTWHITWRLS. Displays2go INTWHITWRLS 4 halaman. Wireless
Juga untuk Displays2go INTWHITWRLS: Panduan Pengguna (15 halaman)
Halaman Cetak• The touch point is
not accurate
• Calibration
interface cannot fill
the screen/
• The projected
image is blurry or
doesn't fill the
screen
• Interactive Surface
doesn't respond
when you touch it,
or gaps appear
when you draw or
write
• Cursor is flickering
or isn't properly
aligned with touch
point.
□
Make sure the whiteboard is placed with the top side facing up. Check the User
Manual and match the unit set up with pictures.
□
Check the resolution of your PC and make sure it matches projector resolution.
❖
If all of the above have been checked and the issue is not resolved, contact a
customer service representative.
□
Restart your PC and try to calibrate the whiteboard again.
□
Adjust the projector's position, Zoom and focus settings. Refer to the projector's user
guide for more information.
❖
If all of the above have been checked and the issue is not resolved, contact a
customer service representative.
□
Clean the reflective film and make sure there's no object or dust block the signal.
Restart the whiteboard and your PC.
□
Check 4 corners on whiteboard to see if the red lights are on. (Each corner has 2 red
lights besides the camera). If the cameras are not working properly, please contact
our customer service representative.
□
Remove the mouse if there's one connected with your PC.
□
Check the if the reflective films need to be cleaned.
□
Check if there are reflective objects around the whiteboard.
□
Check if there are strong lights directly to the cameras
❖
If all of the above have been checked and the issue is not resolved, contact a
customer service representative.
3