Distech Controls Allure ECB-103 Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Distech Controls Allure ECB-103. Distech Controls Allure ECB-103 16 halaman.
Juga untuk Distech Controls Allure ECB-103: Panduan Instalasi (16 halaman)
Halaman Cetak
Device Mounting
Figure 3:
Mounting an Allure EC-Smart-Vue Sensor
Connector and Jumper Location, Identification and Configuration
Allure EC-Smart-Vue sensors have the following onsite configurable jumpers.
Figure 4:
Connector and Jumper Locations
About an Allure EC-Smart-Vue Sensor Equipped with a CO₂ Sensor
The Allure EC-Smart-Vue C/-CM/-CH/-CHM sensors are factory calibrated to accurately read CO
EC-Smart-Vue sensors are used in locations where the elevation is greater than 500ft (152m) above sea level, you must set the Elevation input of the
corresponding ComSensor block in EC- gfx Program to the current location's elevation to obtain the most accurate readings.
For more information, refer to the ComSensor block section in the EC- gfx Program User Guide
Under normal conditions, an Allure EC-Smart-Vue sensor with CO
accuracy after 25 hours of continuous operation on the condition that it was exposed to ambient air reference levels
of 400 ppm ±10 ppm CO
Front Cover, Interior View
PIR
LED
Pass-Through Subnetwork RJ-45 Connectors
D
E
PIR LED
Enabled
Disabled
Motion Detection
Models Only
Local Area Network Type
Jumper
BACnet
.
2
Security
Screw
J6
ON
EOL
OFF
Subnetwork End of Line
Enabled
Disabled
L
W
ON
ORKS
3.5 mm (1/8") Local
Area Network
Access Jack
J11
BAC
LON
sensor will typically reach its operational
2
Wall
Anchors
concentration levels at sea level. When these Allure
2
3 / 16