3D Systems NextDent 5100 Pengaturan - Halaman 2
Jelajahi secara online atau unduh pdf Pengaturan untuk Peralatan gigi 3D Systems NextDent 5100. 3D Systems NextDent 5100 4 halaman.
Halaman Cetak
NextDent
Please see the NextDent 5100 User Guide, found at support.3dsystems.com/nextdent-5100, for safety informa-
tion and comprehensive operating instructions.
Save all foam and packing material for future use. Shipping without the original packing material may
cause damage to the printer.
4. Secure Printer to Pedestal
CAUTION: You must secure
the printer to the pedestal
before use. Failure to do so
could cause the printer to tip
over in certain situations.
1.
Open the pedestal door.
2.
Install all five thumb screws on
inside top of pedestal. Ensure they
are screwed in snugly.
3.
Remove all remaining blue tape
from printer.
6. Level Printer on Pedestal (continued)
3.
You will now adjust the leveling feet.
a.
Keep back-left leveling foot off the ground.
b.
Lower front-right leveling foot until it touches the ground.
c.
Lower front-left leveling foot until it touches the ground. Adjust foot up or down until bubble in level is roughly
centered in the circle left-to-right.
Lower the back-right leveling foot until it touches the ground. Adjust foot up or down until the bubble in the level is
4.
roughly centered in the circle back-to-front.
5.
Verify that the left-to-right level has not changed. Continue adjusting the front-left and/or back-right feet until bubble
is roughly centered in both directions.
6.
Lower back-left foot until it touches the ground. Take care not to lower it too much, so as to throw the level off.
7.
Push lightly on each corner of the machine to ensure it does not rock in any direction.
®
5100 Setup
5. Install Carbon Filter
1
2
1.
Remove thumb screws from filter
bracket. Remove filter bracket.
2.
Slide carbon filter into place
3.
Reinstall bracket with filter and
reinstall thumbscrews.
3
a
b
c
6. Level Printer on Pedestal
1
2
1.
Place the bubble level (included
with printer shipment) on printer
chassis.
2.
The pedestal has four casters
with leveling feet. To adjust each
leveling foot:
a.
b.
4
Turn the orange thumb wheel
to the right to lower it.
Turn the orange thumb wheel
to the left to raise it.