Distech Controls Allure EC-Smart-Comfort-SF-Dl Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Kontrol Distech Controls Allure EC-Smart-Comfort-SF-Dl. Distech Controls Allure EC-Smart-Comfort-SF-Dl 13 halaman.

Halaman Cetak

Installation Procedure

1. Remove the security screw from the device.

2. Open the device by pushing in the tab on its bottom and then by pulling the bottom side of the front plate out.

3. Open the Smart-Light/Blind Series module by pulling the front plate off (if applicable).

4. Plug the Smart-Light/Blind Series modules into the back plate (if applicable).

5. Make sure that the mounting surface is flat and clean.

6. Align the back plate with the wall and mark the location of the mounting holes on the wall (2 holes for the sensor and 1 hole per Smart-Light/Blind Se-

ries module are recommended). Make sure to orient the proper side of the back plate facing upwards.

7. Remove the back plate and drill holes in the wall if necessary.

8. Install anchors in the wall if necessary.

9. Unplug the Smart-Light/Blind Series add-on modules from the back plate (if applicable).

10.Pull all RJ-45 cables and digital wires (if applicable) 15 cm (6") out of the wall, and insert them through the central hole of the back plate.

11.Screw the back plate onto the wall. Do not overtighten.

12.Set the Subnet ID and the EOL termination with the DIP switch as explained in section

[pg. 13].

13.Connect one or two RJ-45 cables into the sensor (reversible).

14.If using digital inputs, connect the digital wires to the digital input cable as specified in section

Cable

[pg. 6], and the digital input cable connector into the sensor as shown on the figure in section

15.Gently push any excess wiring back into the wall.

16.Reattach the front plate and make sure it clips tightly into place.

17.Install the security screw.

18.Plug the Smart-Light/Blind Series add-on modules into the back plate (if applicable).

19.Screw the Smart-Light/Blind add-on module(s) onto the wall. Do not over tighten (if applicable).

20.Attach the Smart-Light/Blind add-on modules front plates (if applicable).

Connectors and DIP Switch Location

The Allure EC-Smart-Comfort sensors have the following connectors and onsite configurable DIP switches.

Only the following models feature the digital input cable connector:

Allure EC-Smart-Comfort-S-DI

Allure EC-Smart-Comfort-SO-DI

Allure EC-Smart-Comfort-SF-DI

Allure EC-Smart-Comfort-SOF-DI

Figure 7:

Connectors and DIP Switch Locations

Setting the Allure EC-Smart-Comfort Sensor Subnet ID

Wiring the Allure EC-Smart-Comfort with a Digital Input

Connectors and DIP Switch Location

[pg. 5].

5 / 13