3D Systems Touch Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori 3D Systems Touch. 3D Systems Touch 19 halaman. 3d stylus hands on design
Juga untuk 3D Systems Touch: Panduan Pengguna (17 halaman)

Halaman Cetak
3D Systems Touch Panduan Pengguna

CALIBRATE THE TOUCH

In this section you will run the Geomagic Touch Diagnostic utility to confirm that the device is properly calibrated.
1.
Click the Geomagic Touch Diagnostic icon on your desktop, or if you chose not to install desktop shortcuts click Start>All
Programs>3D Systems>Geomagic Touch>Geomagic Touch Diagnostic.
Geomagic Touch Diagnostic
The
2.
Click the
Calibrate
tab.
3.
Place the stylus in the inkwell to properly calibrate the device.
Calibration may take up to a second, so do not immediately remove the stylus from the inkwell.
The Calibrate box changes from red to green when the calibration is complete.
4.
When calibration is complete, you can close the Geomagic Touch Diagnostic utility.
The LED lights on the base of the Touch device should be white.
You are now ready to install the 3D modeling software.
NOTE: The other tabs in the Geomagic Touch Diagnostic utility will be helpful for troubleshooting purposes.
DOWNLOAD, INSTALL, AND ACTIVATE
Depending on the 3D software you are installing to use with your Touch device, select from the products below.
For Geomagic Sculpt and Freeform: See the Installation Guide that is associated with the software.
For Cubify Sculpt: Follow the steps below.
1.
Download and install the Cubify Sculpt software from cubify.com/Touch/Activate.
2.
Launch Cubify Sculpt, and when asked if you would like to activate your Touch, click Yes.
Cubify Sculpt closes and opens a folder containing the TouchActivationWizard.exe.
3.
Double-click the TouchActivationWizard.exe to open it.
4.
Enter the
Touch activation
5.
Relaunch Cubify Sculpt and when prompted, enter the Cubify Sculpt
IMPORTANT: Before you install and activate the 3D software, make sure the most up-to-date device drivers are installed,
your Touch device is connected properly, and the Touch is calibrated. If you have installed a trial version, save all your
work files and uninstall the trial version, then follow the steps below.
3D Systems, Inc.
utility opens and you will be in the Mode tab, click the Next Arrow button.
code, then click Activate.
license
key.
10