3D Systems Touch Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Medis 3D Systems Touch. 3D Systems Touch 17 halaman. 3d stylus hands on design
Juga untuk 3D Systems Touch: Panduan Pengguna (19 halaman)

Halaman Cetak

HANDLING THE STYLUS

The correct way to hold the stylus:

Proper Handling

Lifting the stylus out of the inkwell:

attempt to pull the stylus straight out as shown on the right.

Proper Handling

Calibrating the device:

The Touch may need to be recalibrated from time to time, particularly if it has lost power or has been moved.

To calibrate the device, place the stylus in the inkwell and start your application. The LED ring at the base of the Touch device will be lit

White when the device is properly calibrated.

Storing the stylus:

After the device is calibrated, the stylus may be kept in the inkwell or left resting on the desk. Storing the stylus in

the inkwell might increase the risk that the device will be knocked over or that the stylus will be damaged.

3D Systems, Inc.

Grasp the stylus as you would a pen or pencil. Holding the stylus at the bottom, closer to the orb.

Grasp the stylus and lift up to disengage as shown below in the image on the left. Do NOT

The stylus does not need to be stored in the inkwell.

Improper Handling