3D Systems Touch Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Medis 3D Systems Touch. 3D Systems Touch 19 halaman. 3d stylus hands on design
Juga untuk 3D Systems Touch: Panduan Pengguna (17 halaman)

Halaman Cetak
3D Systems Touch Panduan Pengguna
3

SETTING UP THE TOUCH

3
In this section you will download and install device drivers, plug in the cables, then setup and calibrate the Touch device. The
instructions below should be followed in the order they are presented.
Depending on the software (Cubify Sculpt, Geomagic Sculpt or Freeform) you purchased to use with the Touch device, the steps vary
slightly. This is indicated by the product name below.

WHAT'S INCLUDED

Included in the box:
•
Touch 3D stylus
•
Power cord
•
Power supply
•
USB cable
•
Touch 3D stylus Quick Start

INSTALLATION STEPS

1.

Get the Touch Activation Code (Cubify Sculpt Only)

2.

Download and Install the Touch Device Drivers

3.
Connect the Touch
4.
Touch Setup
5.
Calibrate the Touch
6.
Download, Install, and Activate
GET THE TOUCH ACTIVATION CODE (CUBIFY SCULPT ONLY)
1.
Go to cubify.com/Touch/Activate.
2.
Enter the Touch Serial number, then click Activate.
NOTE: The Touch Serial number is located on the bottom of the Touch device and on the Touch box.
The Touch activation code displays along with a license key for Cubify Sculpt. You will also receive an email with this information.
You will use the Touch activation code and the Cubify Sculpt license key later when you download, install and then start the Cubify
Sculpt software for the first time.
DOWNLOAD AND INSTALL THE TOUCH DEVICE DRIVERS
You will need to download and install the most up-to-date Geomagic Touch Device Drivers (GTDD).
For Geomagic Sculpt and Freeform users: To download and install the Geomagic Touch Device Drivers, go to
geomagic.com
then click on the 3D modeling product you purchased. Click the product download, then locate the Geomagic Touch
Device Driver executable. Download and follow the Installation Wizard to install the device drivers.
For Cubify Sculpt users: To download and install the Geomagic Touch Device Drivers, go to
Device Drivers. Download and follow the Installation Wizard to install the device drivers.
In addition to installing the device drivers, the install also includes the Geomagic Touch Setup and the Geomagic Touch Diagnostic
utilities.
NOTE: At this time, you can also download the 3D software from the same location, however, do not install the software
yet.
3D Systems, Inc.
6
gettingstarted.
cubify.com/Touch/Activate
then click