Acoustic Image Clarus 2R Panduan Pemilik - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Acoustic Image Clarus 2R. Acoustic Image Clarus 2R 8 halaman.
Halaman Cetak
Specifications
System
Frequency Response
20 Hz - 20 kHz, ±0.5 dB
Distortion
<0.5%, full output, <0.1%, typical
Hum and Noise
-85 dB or better
AC Power
115V/60 Hz or 230V/50 Hz, switchable
Japan version is 100V, 50/60 Hz only
Size
10x8x3.5 inches (Clarus/Focus)
10x6.5x3.1 (Focus SA)
Weight
Less than 5 lbs for all models
3.5 lbs (Focus SA)
Preamp (Mic and Instrument Inputs through combo jack)
Mic Input
600 ohm balanced, XLR connector
Phantom Power
38 volts, on/off switch w/LED indicator
W
Instrument Input
1 M impedance, 1/4 inch jack
Direct Out
+4 dB, balanced, XLR connector, ground lift,
pre/post EQ selector
Effects Loop
Parallel type with return level control
Bass Control
Shelving type, ±15 dB at 60 Hz
Mid Control
±15 dB at 650 Hz
Treble Control
Shelving type, ±25 dB at 10 kHz
Notch Filter
>-18 dB sweepable from 30 to 800 Hz
Low Cut Filter
-12 dB/octave sweepable from 30 to 800 Hz
Effects (Clarus 2R and Focus 2R))
Type
Digital with 6 presets and level control
Program Presets
3 reverb (hall, room, plate), delay, ambient
chorus, flange
Power Amp (all models)
Topology
Class D (PWM)
Switching Frequency
230 kHz
Output Power-Clarus
>250W (8
Output Power-Focus
>
450
W (8
W
Minimum Load
2
Output Connectors
Neutrik Speakon type (pole 1)
Input (Focus SA only)
XLR-1/4 in combo jack, 5k
Sensitivity (SA only)
250 mVrms for full output ("instrument level")
Included Accessories
Gig bag with shoulder strap, 6 foot
Speakon to 1/4 inch cable
Warranty Information
Serial Number _______________
Acoustic Image
5820 Triangle Drive
Raleigh, NC 27617
9
W ) ,
W
W
>400 W (4 ), >500W (2 )
W ) ,
W
W
> 00 W (4 ), >
8
1000
W (2 )
W
Phone: 919-785-1280
Fax: 919-785-1281
www.acousticimg.com
FCC Compliance Notice
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and
receiver.
--Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician
for help.