3DGence DT3 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Printer 3D 3DGence DT3. 3DGence DT3 14 halaman.

3DGence DT3 Manual

Maintenance

IMPORTANT: Always unplug the 3DGence DT3 from
its power source before doing any maintenance.
• There may be a periodic need to clean the pump
suction strainer or manifold that distributes the
circulating water. If you notice a significant decre-
ase in the circulation of water, there may be a
buildup of material blocking circulation flow.
(1) Unplug and drain the 3DGence DT3 per the
Operating instruction step 10 (remember to wear
safety protection).
(2) Remove and dry the tank lid before placing on
another surface.
(3) Inspect the suction strainer (see Figure 4) and
remove any material deposits. It maybe necessary
to replace the strainer if the mesh becomes
excessively coated with deposits.
(4) Using a 7/16" socket, loosen (but do not
remove) the 1/4"-20 nuts (see Figure 4) located
behind the holes at the top of the jet plate. Remove
the jet plate by lifting using the top holes provided
for the 1/4"-20 nuts. As with the
tank lid, dry before setting aside.
(5) If a significant amount of material is found and
removed from the suction strainer, the manifold
may not need cleaning; skip to step (9) to re-install
the jet plate. If the manifold appears to have mate-
rial blocking the holes, proceed to
the next step (6) to remove and clean the manifold.
jet plate
2ea 1/4-20 nuts
strainer
(6) Using a 5/16" socket, loosen the hose clamp
connecting the manifold hose and remove the
10-32 screws with a 1/8" Allen wrench. Then
completely remove the manifold (see Figure 4).
(7) Remove material blocking the jets by either
pulling the material through the holes, or flushing
through the inlet of the manifold.
(8) Re-install the manifold and tighten the hose
clamp.
(9) Re-install the jetplate. Slide the jet plate
between the washers and the tank. Be careful not
to over-tighten the nuts, for easier removal in the
3DGence DT3
3DGence DT3
Jet action cleaning
Jet action cleaning
Manifold
2ea 10-32 BHCS
Figure 4