Alto X-P234 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Crossover Alto X-P234. Alto X-P234 18 halaman. 2-way/3-way stereo, 4-way mono active crossover
Juga untuk Alto X-P234: Panduan Pengguna (8 halaman)

Halaman Cetak

6.Low/High XOVER FREQ. Multiplier

Combined with the usage of the Low/High XOVER FREQ. (3) knob on the front panel, this button can switch

the crossover frequency range to 440Hz to 9.3kHz.

Please ensure that, your speaker management system must be powered off before you proceed this switching,

otherwise, the offensive switching noise can be heard through your speakers.

8.Operation Mode Option

Press the left button, and release the right button to enter into the stereo 2-way operation mode.

9.Low Sum Control

Press this button to sum up the low frequencies output of Channel1 and Channel2, and the summed signal

can be output from Channel1.

14.Input Connector

These two balanced XLR connectors are used to input the stereo program sources.

4. INSTALLATION & CONNECTION

4.1 Mains Connection

Please ensure that the

power cord into the wall outlet , use the same fuse as marked on the fuse holder at the AC power connection socket.

The mains connection of the

standard IEC receptacle. It meets all of the international safety certification requirements.

4.2 Audio Connection

The

LTO X-P234 Active Crossover

ways to support a variety of applications without any signal loss.

a. Wiring Configuration

Either the 1/4" TRS (Tip-Ring-Sleeve) jack or the XLR servo connector can be wired in balanced and unbalanced

modes. Please wire your systems as the following examples:

For 1/4" Phone jack

TS Type Unbalanced

For XLR connector

XLR Type Unbalanced

LTO X-P234 Active Crossover is set to the correct supply voltage before plug

LTO X-P234 Active Crossover is made by using the enclosed mains cable and a

presents with balanced XLR connectors, and it can be interfaced by several

Tip

Sleeve

Pin2 (+)

Pin3 (-)

(Linked to Pin1 manually,

Pin1 ( )

Tip

Ring

Sleeve

TRS Type Balanced

Pin3 (-)

)

Tip

Ring

Sleeve

TRS Type Unbalanced

Pin2 (+)

Pin1 ( )

XLR Type alanced

ging

the