AkitikA PAT5RCA Panduan Instalasi - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penguat AkitikA PAT5RCA. AkitikA PAT5RCA 12 halaman. Dynaco pat-5 preamp replacement rca jack
Halaman CetakYou'll definitely find that it's tight quarters. On my PAT-5, I cut all the wires close to the
original jacks, and had enough slack to move them to the new jacks. You might choose to
de-solder the wires from the old jack. I worked one jack field at a time, and transferred
just one wire at a time.
Re-installing the new jacks
Work the new jacks carefully back into the chassis, being careful not to over-stress the
(mostly) solid wires that connect them. Some hints:
Install the screws and nuts loosely.
Make sure that the lugs sit between the chassis and the RCA jack PCB.
A little sticky tape on the end of a screw-driver makes a nice way to hold 4-40
nuts in hard-to-get-to places until you can get the screw started.
There's a bit of slop in the mounting screw locations in the chassis. My samples
went together fine, but there's a possibility that the mounting holes on the PCB's
should have been about 0.06" further apart. I had to insert the second end's screws
on an angle, but then they straightened up ok upon tightening. Until I've heard
from enough of you, I can't be sure if my PAT-5 sample was completely
representative.
Re-assembling the preamp
1. Re-install the two 4-40 screws and nuts that fasten the back panel to the power
supply mounting plate.
2. Re-install the 5 screws that hold the PAT-5's cover in place.
Page 12 of 12