Baltech TL-0215C Panduan Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Termometer Baltech TL-0215C. Baltech TL-0215C 20 halaman. Tl series

3.3.2 Operation modes of the device

To select an operation mode and set up parameters of the

device, use the button «MODE». The selection of the

required mode is performed by multiple pressing of a button

and through control of the required mode on the device

display. The device operation modes and sequence of their

selection are shown on the figure 3.4. After the mode is

selected, press the measurement start button and start

measuring. Release the button to switch off the device. The

device will switch off in about 6 seconds.

Operation mode

Parameter Setup

1. Scanning and displaying

temperature during

measurement

2. Maximum temperature

during measurement

3. Minimum temperature

during measurement

4. Average temperature

during measurement

5. The difference between

the maximum and the

minimum temperature

during measurement

6. Recalling the stored

measurement results by

using

7. Setting of a controlled

surface emissivity

8. Setting of the highest

alarm temperature

9. Setting of the lowest

alarm temperature

(The parameters are set

with ▼ or ▲ buttons)

Figure 3.4

buttons.