ESE ES-562U Panduan Pengoperasian dan Pemeliharaan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemeliharaan untuk Pengatur waktu ESE ES-562U. ESE ES-562U 7 halaman. Combination clock / timer

Halaman Cetak

"C" -

When this option (Crystal Timebase) is specified, a trimmer is included for greater accuracy.

The crystal (.002% accuracy) is factory calibrated to provide an accuracy of 2-3 seconds per

week and can also be field adjusted for greater accuracy.

"D" -

When this option is specified, a standard 6' remote cable which attaches to the rear-mounted

9-Pin connector is provided. All function controls (TIMER, UP/DOWN, SET/STOP,

SELECT/RESET and TIMER) are mounted on a 1/8" clear anodized aluminum switch plate.

Extra cable length is available upon request.

"HR" -

When this option "HR" (Hour or Hour & Half-Hour) is specified, a relay contact closure occurs

on the Hour or on the Hour & Half-Hour (CLOCK time). The contacts are rated at 10 watts

maximum resistive load, 500mA maximum switching current. The contact closure is accessible

on the rear-mounted DB9 connector (see page 3). NOTE: Unless otherwise specified, Option

"HR" includes a closure on the Hour & Half- Hour. A jumper on the PCB allows the Half-Hour

feature to be defeated.

"J" -

When this option is specified, input voltage is 220 VAC, 50/60Hz.

"P" -

When this option is specified, the unit is housed in an Etched aluminum rackmount enclosure

– 1.75" high x 19" wide x 10" deep.

"P2" -

When this option is specified, a 19" rackmount panel allows any two units with a "P2" option to

be mounted side by side.

"Q" -

When this option is specified, the unit is housed in a console mount enclosure with an etched

aluminum front panel – 3.5" high x 9" wide x 8" deep.

"R" -

When this option is specified, all functions are accessible via a 9-Pin connector (see page 3).

"UL" -

When this option is specified, the unit is supplied with a UL approved wall mount power

supply.

"W" -

When this option is specified, the unit is supplied with a three wire line cord.

"ESE" -

When this option (Serial Time Code output) is specified, the Time Code output is accessible

via a rear BNC connector. The time code output is the same as what is currently being

displayed.

OPTIONS

Page 2