3DTV STEREODRIVER X Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kacamata 3D 3DTV STEREODRIVER X. 3DTV STEREODRIVER X 4 halaman.
cable. In either case, you may connect the other RCA on the
StereoDriver to the video in on your TV or connect the round RF cable
from the VCR, VCD, DVD or STB to the TV. Some older equipment
may not have enough power via the SCART cable, so if the light on the
StereoDriver is dim or out, give it power directly from any DC adapter
which makes it's green LED go on.
IF THE GLASSES PERFORM ERRATICALLY, THE MOST PROBABLE CAUSE IS
FAILURE TO CONNECT VIDEO TO THE STEREODRIVER. Make sure the
connectors are plugged in all the way, the battery is connected and has
approx. 9Volts and the red LED power is on. If they image looks
strange press the polarity (mode) button to reverse the eyes. If the
red LED on the right is flickering you are not getting good video into the
unit.
ELIMINATE FLICKER BY REDUCING ROOM LIGHT AND TURNING DOWN
THE BRIGHTNESS OF YOUR TV. ADJUST THE COLOR, BLACK LEVEL,
AND SHARPNESS WHILE VIEWING THE 3D PICTURE WITH THE GLASSES.
It is important to keep the glasses free of fingerprints and to avoid rear
light which reflects off the inside of the glasses.
IT CANNOT BE TOO STRONGLY EMPHASIZED THAT OPTIMAL 3D WILL
ONLY BE SEEN IF YOU CAREFULLY ADJUST THE BRIGHTNESS, BLACK
LEVEL, COLOR LEVEL, TINT, AND SHARPNESS WHILE OBSERVING.
WITH MANY TV SETS THIS WILL REQUIRE SWITCHING OFF THE
AUTOMATIC CONTROLS. WITH COMPUTERS YOU CAN ADJUST YOUR
MONITOR AND/OR VIDEO CARD OR THE CONTROLS IN THE SOFTWARE.
IT IS ESSENTIAL TO KEEP THE GLASSES CLEAN - A SINGLE FINGERPRINT
WHJL RUIN THE 3D! YOUR ABILITY TO VIEW 3D WILL IMPROVE WITH
PRACTICE.
WARNING
Do not use this product or any 3D Viewing system for prolonged
periods. It is not a toy and should not be used by epileptics or children
under seven years of age. If you or your child experience any of the
following symptoms, discontinue use immediately and consult your