esera 11169 V1 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori esera 11169 V1. esera 11169 V1 9 halaman. 1-wire outdoor - multisensor pro professional environmental monitoring via outdoor - multisensor
Juga untuk esera 11169 V1: Panduan Cepat (4 halaman)
Halaman Cetak
Art. No. 11169 V1
8
LED Display
LED
Function
green
lights up with Power
Power On display
yellow
Status
Sensorfinder
9
Software / Control
The EOS 100 is read out via 1-Wire command for DS2438 devices. The Multisensor is supported in many
controllers, such as ESERA-Station, PLC controllers, Loxone, IP-Symcon, OWFS, FHEM, (Linux) or
microcontroller applications.
For ESERA 1-Wire Outdoor - Multisensor of the Pro Series no complex formulas are necessary anymore.
A sensor controller within the Multisensor takes over the preprocessing of all measured values and thus
simplifies the integration into 1-Wire systems enormously. Complex formulas are no longer necessary. The
measured values are also no longer dependent on the operating voltage of the 1-Wire Outdoor - Multisensor.
The sensor measurement values are assigned to the standard DS2438 device values (according to the data
sheet) as follows:
VDD = operating voltage (5V), VAD = humidity, Xsens = air quality.
Calculations
Temperature
Standard output according to DS2438 protocol
Operating voltage (Vcc)
Standard output according to DS2438 protocol
Air humidity (Vas)
To get the rel. humidity in percent, multiply the output value (Vas) by factor 10.
0.1V corresponds to 1% relative humidity
Xsens is output with permanently 0
10
Data output 1-Wire Controller / 1-Wire Gateway
For the EOS 100, subsequent measured values are output via the 1-Wire Controller/1-Wire Gateway.
A library for this sensor is integrated in all ECO Controllers. This is automatically assigned to the sensor via
Auto-E-Connect.
Data output:
1_EVT|12:27:40
1_OWD1_1|2008
1_OWD1_2|100
1_OWD1_3|850
1_OWD1_4|1200
For further information on the options and commands, please refer to the current documentation or the
programming manual of the 1-Wire Controller.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021
www.esera.de
=> Controller No._module No._Data set|temperature (°C) example: 20,08 °C
=> Controller No._module No._Data setz|Power Good, 0=fault, 100 = OK
=> Controller No._module No._Data set|air humidity (rF) example: 85,0%
=> Controller No._module No._Data set|dew point (°C) example: 12,00 °C
11169 V1.0 R1.1 Manual
description
-
The power LED lights up as soon as the power supply
is applied to the device.
-
The LED flashes as a sign of the start phase.
-
In operation, the LED flashes when reading the sensor
via the 1-Wire Bus.
-
Per 1-Wire "Sensorfinder command", the LED can
blink continuously or light up permanently. This
function is used to quickly find the addressed sensor
during installations.
The sensor finder command can be sent via ESERA
ECO Controller, from the ECO 100 series on via the
1-Wire Bus.
Page 5 of 9