3DUpFitters Ender 3 S1 Enclosure Kit Panduan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D 3DUpFitters Ender 3 S1 Enclosure Kit. 3DUpFitters Ender 3 S1 Enclosure Kit 17 halaman.

Halaman Cetak

Use the long screws included in the fan packet to attach the fan. The length of the

screws may change depending on the depth of this

particular shipment of fans.

The back panel also contains the removable grommet

cable portal. Locate the grommet and insert it into the

grommet holder. This is where you'll insert the power

cable, USB cable, and any other wires you want to run

in or out of the enclosure.

Insert the grommet holder/grommet combination into

the U-shaped hole in the right-side panel. This will enable

you to slide the enclosure oﬀ and onto the printer without

unplugging the cables.

3DUpFitters Ender 3 S1 Enclosure Kit Panduan Instalasi - Halaman 10

4. Right Panel