3DUpFitters Ender 3 S1 Enclosure Kit Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D 3DUpFitters Ender 3 S1 Enclosure Kit. 3DUpFitters Ender 3 S1 Enclosure Kit 17 halaman.

Halaman Cetak

6. Install Vents

You should now place the enclosure over the 3D printer.

The front fresh air vent is inserted

from the outside and attached using

M4 12mm screws. This will bring in

cold air to the air intake vent of the

case, cooling the electronics inside.

It's important to keep the fan on the

back panel running in order to help

draw air through the case's vents

and to the outside, especially when

printing PLA and PETG.

If you forget to turn on the fan

when printing PLA your printer will

probably clog.

If that happens use a 3D printer needle (available in many places online) to remove the

clog. This technique is easy and works most of the time.

It is acceptable to turn oﬀ the fan when printing ABS or ASA in order to bring the

temperature into the ideal range, but be sure to turn the fan back on when you're

ﬁnished, especially if you are venting or ﬁltering the air to remove VOCs.

Note that the lid ﬁts right into the vent slots,

helping to form a seal. Slide the 3D printer

towards the front up against vent.

The right tray is labeled as such and is

inserted from the outside as well. As you

insert the tray be sure to lift up the right side

of the printer so that the tray slides under

the square rubber foot. This foot ﬁts into

the square hole in the vent.