3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Panduan Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 halaman.
Juga untuk 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Panduan Instalasi (16 halaman)

Halaman Cetak

CR-6

The CR-6 display mount looks like the piece to the right,

and attaches to the two screws in the corner connector on

the right-side panel. The cable ﬁts through the slot, while

you can mount the display to the front using 14mm M4

screws and nuts.

Ender 3 V2

The new Ender 3 has a diﬀerent display

that inserts into a mounting platform that

also attaches via the two corner

connector screws on the right panel.

Rather than use the 12mm M4 screws as

before, you'll use the longer 16mm M4

screws to attach both the corner

connector and the display mount.