esera automation ECO 10 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol esera automation ECO 10. esera automation ECO 10 13 halaman. 1-wire controller

Halaman Cetak

esera automation ECO 10 Panduan Pengguna

Art. No. 11601-24

Note

Please also refer to the operating instructions for Config Tool 3, which you will find under the

"HELP/SUPPORT" tab within Config Tool 3.

Furthermore, you will find a video about the firmware update on our website under "Service and Support,

Support Videos".

17.1

Recovery function Firmware-Update

If the update is faulty, e.g. due to a power failure during the update, you can use the

recovery function. To do this, press and hold the reset button (this is located under

hole 11 on the top of the module), start the update in Config Tool 3 and release the

reset button after approx. 1 second after starting in Config Tool 3. The update should

now start.

After performing an update, we recommend that you disconnect the ECO 10 from the

power supply for approx. 30 seconds and restart it.

If you have any problems with the installation, we will be happy to help you. Simply

contact our support team by e-mail ([email protected]

Note

After carrying out an update, we recommend that you disconnect the ECO 10 from the power supply for

approx. 30 seconds and restart it.

Pressing the reset button does not correspond to an interruption of the power supply.

Example for integration in IP-Symcon

We provide ESERA IP-Symcon software modules for easy integration of the ECO 10 into IP-Symcon via our

website. This gives you seamless integration into the software.

Details can be found on the ESERA website under "Compatible controllers / Control units / IP-Symcon

integration".

https://www.esera.de/kompatible-steuerungen-zentralen/ip-symcon-integration/

Example for Integration in Loxone

Via the shop we provide a sample project for the simple integration of the ECO 10 into the Loxone Miniserver.

This allows you to expand the Miniserver with many 1-Wire functions.

Details can be found on the ESERA website under "Compatible controllers / Control units / Loxone integration".

https://www.esera.de/kompatible-steuerungen-zentralen/loxone-integration/demo-1-wire-controller-1-loxone-

integration/

Example for Integration in FHEM

For integration into the open source automation software FHEM, we provide a software module for easy

integration of the ECO 10. This provides you with a very powerful 1-Wire interface in FHEM.

Details can be found on the ESERA website under "Compatible controllers / Control units / FHEM integration".

https://www.esera.de/kompatible-steuerungen-zentralen/fhem-integration/

Example for Integration in KNX Automation

For integration into a KNX automation system, we offer a software module for the Gira Homeserver together with

Grot company. This provides you with a very powerful 1-Wire integration for your KNX system. Details can be

found on the ESERA website under "Compatible controllers / Control units / KNX Gira Homeserver".

https://www.esera.de/cat/index/sCategory/339

* if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.

ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021

www.esera.de

11601-24 V1.0 R1.1 Manual

Page 11 of 13