ClearCube A3000 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Server ClearCube A3000. ClearCube A3000 2 halaman. Clearcube a3000 chassis: quick start
Juga untuk ClearCube A3000: Panduan Memulai Cepat (2 halaman)

Halaman Cetak
Ground Strap
(attach with 10-32 screw)
Ground Strap
(attach to rack frame)
CAUTION: High Leakage Current
Connect chassis earth ground
before supplying AC power
to chassis.
WEEE Initiative Notice
This electronic product is recyclable under
WEEE (Waste Electrical and Electronic
Equipment) guidelines and should not
be discarded as regular trash.
Please locate your nearest recycling facility
to ensure proper disposal of this product,
or contact ClearCube Technology
on the web at:
http://support.clearcube.com/
or by email at:
for more information.
ClearCube Technology
INSTALLING BLADES
A Series blades need to be pre-configured before installing them in the
chassis. You need a VGA monitor with a DB-15 mini connector, a keyboard,
and a mouse. The keyboard and mouse can be USB or PS/2. An IEC power
cord is also required. For more information, please see the A Series Data
Center Products User's Guide or the A1010 Quick Start Guide.
To install an A Series blade in the A3000 chassis, do the following:
1. Remove the front bezel on the chassis by pressing the latch on the
right side of the chassis toward the left of the chassis.
2. Tilt the bezel forward, and lift it free from the chassis.
3. Orient each PC blade right-side up, with the D-shaped cutout in the front
panel on top, then slowly insert the PC blade into the chassis by lining up
the PC blade edges with both the top and bottom guides in the chassis.
4. Slots are numbered from 1 to 10, starting with the left-most slot. There
will be a slight resistance to insertion when the rear connector goes into
the backplane power connector. When properly seated, the PC blade is
flush with the front edge of the bottom guide bracket.
5. After inserting all the blades, replace the bezel.
6. Attach an ethernet cable to each blade. The ethernet cable engages a
latch that secures the blade inside the A3000 chassis.
7. Press the power button (the top button) to turn on each blade. When
you insert the PC blade, the power does NOT turn on automatically. You
must depress the power button on the back of the blade to power it on.
To remove a blade, do the following:
1. Remove the front bezel on the chassis by pressing the latch on the
right side of the chassis toward the left of the chassis.
2. Power down the blade using the power switch on the back of the blade.
3. Remove the ethernet cable from the blade. If necessary, push up gen-
tly on the latch on the ethernet jack.
4. Pull gently on the blade until it slides out. Use the D-shaped cutout on
the front panel as a handle. Be sure to support both ends of the blade
when you remove it completely from the chassis.
For more information, please contact ClearCube Technical Support.
Email:
Website:
In the US
Outside the US
8834 Capital of Texas Hwy N
Austin, Texas 78759
support.clearcube.com
(866) 652-3400
+1 (512) 652-3400
voice 512 652 3500 www.clearcube.com
G020079-E rev 10/17/2006