esera automation Auto-E-Connect 11230 Panduan Pengguna
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem I/O esera automation Auto-E-Connect 11230. esera automation Auto-E-Connect 11230 6 halaman. 4-fold analog input insulated for 1-wire bus
Art. No. 11230
4
input channels with 0-10VDC measuring range
electrical insulation between analog and Bus area
analog converter with high 12-bit resolution
analog inputs with overvoltage protection
input filter for "calmed" measured value acquisition
DIN rail housing for control cabinet installation according to
DIN EN 50022
screw terminal connection
easy to assemble
housing colour green
1
Introduction
Before you start the installation of the 4-fold analog input and put the device into operation, please read these
installation and operating instructions carefully to the end, especially the section referring to the safety
instructions.
2
Product description
With the 4-fold analog input insulated, sensors with DC voltage output such as pressure sensors, light
sensors, setpoint generators or other sensors with 0-10V output voltage with galvanic isolation can be easily
measured. The triggering of the analog converter is fixed at 12Bit.
With the 4-fold analog input insulated DC voltages or sensors can be monitored with low load of the sensor.
The 4 input channels are galvanically insulated from the 1-wire bus and the supply voltage. This allows analog
signals from sensors or modules to be measured with different potentials. The isolation avoids effects caused
by ground loops due to potential differences. In order to obtain "calm measured values", the module has
optimally adapted filters in the input area.
The input channels have a common ground potential. If different analog signals with different potentials are to
be measured, separate modules must be provided.
We will be pleased to advise you on the possible applications.
3
Auto-E-Connect® Support
The ESERA Auto-E-Connect® 1-Wire Plug and Play system will be used for the
1-Wire Bus supported. This enables fully automatic configurations of 1-Wire sensors
and actuators on the 1-Wire bus. It is optimized for industrial applications and
enables significant added value beyond the sensor and chip data.
The Auto-E-Connect function automatically recognizes ESERA chips, sensors and actuators, starts suitable
libraries and outputs fully formatted data.
The Auto-E-Connect functionality will be available from mid-2020 via 1-Wire Controllers, 1-Wire Gateways and
1-Wire ECO from ESERA available. Further information on ESERA Auto-E-Connect can be found on the
ESERA website, ESERA Config-Tool 3, or in the download area for this article in the ESERA Webshop.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
User Guide
4-fold analog input insulated
for 1-Wire Bus
11230 V2.0 R1.0 Manual
Page 1 of 6