3DUpFitters Prusa i3 MK2 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D 3DUpFitters Prusa i3 MK2. 3DUpFitters Prusa i3 MK2 18 halaman. Enclosure kit
Juga untuk 3DUpFitters Prusa i3 MK2: Panduan Instalasi (11 halaman)

Halaman Cetak
Assemble Panels
1. The Front Door
Each of the corners on the enclosure will be held together by the connectors pictured
below. There are only two versions L and R, which can be identified by the letters
stamped on the inside. The diagonally opposite connectors are identical, i.e. Bottom
Right is the same as Top Left. In all cases the surface of the connector with the cutout
pattern faces front or back. Note the two pictures below show the inside of the front
panel.
If the holes don't seem to line up please check out this video!
https://www.3dupfitters.com/blogs/news/how-to-attach-corner-connectors
Top Left (L)
Bottom Left (Labeled R)
R-Connector From Inside
Copyright 2020 3DUPfitters LLC
Top Right (R)
Bottom Right (Labeled L)
6