ClearCube clientcube 2 Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih ClearCube clientcube 2. ClearCube clientcube 2 15 halaman. Secure kvm or secure km switch

Halaman Cetak

Navigating OSDs and VMs

Using the

keyboard

Mouse control:

OSD and VMs

ClearCube Technology, Inc.

Note that in many cases you can use the keyboard instead of the mouse when navigating the OSD and

when making connections to VMs. You can use the keyboard's TAB key and arrow keys to move

focus on dialog box elements, and press the ENTER key to make selections. In many cases, this can

eliminate the need to use the mouse and toggle mouse modes as described below.

When using zero clients with a Belkin Secure KM, special keyboard keystrokes are required to

control the connected mouse when zero clients are in a pre-session state (using the zero client on-

screen display [OSD] shown below) and before configuring VMs. The keystrokes toggle mouse

behavior modes for use on the zero client OSD and when configuring VMs for use with a KM. The

picture below shows the zero client OSD.

The list below shows the keystrokes that toggle mouse modes.

 CTRL, CTRL, F11, b

This keystroke sets relative mode. Press this key combination when using the mouse to navigate

the OSD (and in VM sessions before configuration).

 CTRL, CTRL, F11, c

This keystroke sets absolute mode. Press this key combination when using the OSD (and in VM

sessions before configuration) to enable Seamless Cursor Switching (to move from one monitor to

another). To re-gain control of mouse movements, press CTRL, CTRL, F11, b as described above.

NOTE

When connecting to VMs, zero clients must use TERA firmware 4.2.0. See

PCoIP Device and Firmware Compatibility Guide and PC-over-IP (PCoIP)

System User's Guide for information about upgrading firmware.

3700 W Parmer Lane

Figure 4.

The zero client OSD

Page 9 of 14

Austin, TX 78727

P/N G0200161 Rev F, 1.5.01.19.2015

(512) 652-3500